Будь ласка, використовуйте цей ідентифікатор, щоб цитувати або посилатися на цей матеріал: http://elartu.tntu.edu.ua/handle/123456789/2882

Назва: Дослідження закономірностей накопичення втомних пошкоджень у зварних з’єднаннях
Інші назви: Research of the fatigue damage accumulation regularities in the welded joints
Автори: Соловей, С.
Solovei, S.
Бібліографічний опис: C. Соловей. Дослідження закономірностей накопичення втомних пошкоджень у зварних з’єднаннях / C. Соловей // Вісник ТНТУ. — 2013. — Том 71. — № 3. — С.164-169. — (механіка та матеріалознавство).
Дата публікації: 2-сер-2013
Дата внесення: 24-лют-2014
Видавництво: Тернопільський національний технічний університет ім. Івана Пулюя
Місце видання, проведення: Тернопіль, Україна
УДК: 539.4
Теми: накопичення втомних пошкоджень
високочастотна механічна проковка
циклічна довговічність
втома
зварне з’єднання
accumulation of fatigue damages
high-frequency mechanical peening
fatigue life
fatigue
welded joint
Короткий огляд (реферат): Експериментально досліджено вплив послідовності прикладення навантажень (зростаючої, спадаючої та квазівипадкової) на циклічну довговічність зварних з’єднань низьколегованої сталі 09Г2С при багатоступеневому та блоковому навантаженнях. За гіпотезою лінійного підсумовування втомних пошкоджень встановлено відповідні граничні значення накопиченої втомної пошкодженості до руйнування зразків залежно від виду та послідовності прикладених навантажень. Показано, що при блоковому навантаженні зварних з’єднань порядок прикладення навантажень у блоці істотно не впливає на значення накопиченої втомної пошкодженості таврових зварних з’єднань, які знаходяться у діапазоні від 0,60 до 0,97.
The paper is devoted to establishing the regularities of fatigue damage accumulation in welded joints at multistep and block loading with different sequences of load application in the block. Fatigue testing was conducted on specimens of welded tee-joints of low-alloyed structural steel 09G2S at zero-to-tension alternating cycle with the frequency of 5 Hz. Different sequences of load application (increasing, decreasing or quasirandom) were assigned by 5 loading steps. Hypothesis of linear summation of fatigue damage was used to establish the respective boundary values of accumulated fatigue damage of specimens, depending on the kind and sequence of applied loading. It is shown that at multistep loading of welded joints, the sequence of load application essentially influences cyclic fatigue life of welded joints. Boundary values of accumulated fatigue damage of the joints before fracture at increasing sequence of applied loading are in the range from 0.32 to 0.56, at decreasing sequence – from 1.48 up to 1.97 and at quasirandom sequence – from 0.84 to 1.24. Thus, the sequence of load application to welded joints causes an opposite effect in terms of regularities of fatigue damage accumulation compared to base metal. It is established that the range of boundary values of accumulated fatigue damage at block loading (0.60…0.97) is four times narrower than the range of values of boundary total damage at multistep loading (0.32…1.97). While calculating the cyclic fatigue life of welded joints subjected to block loading by the hypothesis of linear summation of fatigue damage, it is recommended to take boundary value of accumulated fatigue damage of 0.6 as the damage criterion.
URI (Уніфікований ідентифікатор ресурсу): http://elartu.tntu.edu.ua/handle/123456789/2882
ISSN: 1727-7108
Власник авторського права: © „Вісник Тернопільського національного технічного університету“
Статус публікації : Опубліковано раніше
Тип вмісту: Article
Розташовується у зібраннях:Вісник ТНТУ, 2013, № 3 (71)



Усі матеріали в архіві електронних ресурсів захищені авторським правом, всі права збережені.